Hardness Tester, Shore A C D Hardness Tester Portable Durometer For Vulcanized Rubber Silicone Tire Plastic Products Usage Hand-Held Measure Tool,Excellent Portability(C Type-Two Pins)

Pointer Shore Hardness Tester Dial value: 0-100 degree Needle size: 0-2.5 mm. Pressure at end of needle: Type A: 0-100HA Type C: 0-100HC Type D: 0-100HD A - Shore Type Durometer 1. Pointer Shore hardness tester is widely used in the hardness test of vulcanized rubber and plastic products. 2. It has the characteristics of simple structure, convenient use, small size and intuitive reading. 3. You can carry manual measurements with you 4. It can be installed on the support test bench of the same type of durometer Shore for constant load testing. 5. Meet DIN53505, ASTM D2240 ISO/R868, JIS R7215 C - Shore Type Durometer 1. Pointer Shore hardness tester has three types: A, C and D 2. Type A is generally suitable for testing the hardness of low and medium hardness materials such as rubber, synthetic rubber, polyresin, felt, leather, wax, etc. 3. Type C is suitable for some rubbers with a compression rate of 50% and a tension greater than 0.049MPa. Hardness test of similar footwear microporous materials made of plastic containing foaming agent 4. Type D is generally suitable for testing the hardness of hard rubber, hard resin, plexiglass, printed boards, materials for flooring, bowling balls and other high hardness materials. Instructions Note: Double needle Shore hardness tester does not need to read within 1S. After testing the double-needle Shore durometer, the driven needle will remain on the numerical scale of the test until the compression screw is turned to zero. Portable Shore Durometer A,C,D, Type Hardness Tester for Vulcanized Rubber, Silicone and Plastic Products, Manual Measurement Digital Durometer Shore Hardness Tester, Shore Rubber Durometer Hardness Tester, Durometer Shore Hardness Meter

• 1. Place the sample on a solid surface, hold the hardness tester with the hardness tester panel and the operator at a direct viewing angle, and the penetrator is at least 12 mm from the surface of the tested sample.
• 2. Press the hardness tester on the sample constantly, until the presser foot is in full contact with the sample and the presser foot is in full contact with the sample to be tested, reading within 1S.
• 3. Each sample will be tested at least 5 times and the distance between each test point shall be at least 6mm.
• 4. After the test, take the average value (the distance between the measurement points of the microporous material is at least 15 mm)
• 5. For stabilize the test conditions and improve the test accuracy, the durometer should be installed on the Shore durometer supporting model for testing.